Electrical tests laboratory

ELECTRICAL TESTS LABORATORY

C2MI can perform several types of electrical testing. Electrical tests are performed to ensure the quality and reliability of long-term devices or for collection purposes to eliminate the few devices that are failing or measure and collect information on changes induced by radiation in the characteristics of the component.

Functionality tests

The functionality test aims to eliminate the bad processes in a limited period of time to spare the costs as much as possible. On modern testers, components found on modern testers are tested with a higher parallelism. In other words, components are increasingly tested simultaneously. So, it almost possible to divide the test of time by the number of components in parallel. There is another method to reduce the test time. This is to adapt the component itself in DFT test.

During the test, the components are commonly manipulated by machines called “Handler”. Some handlers used to test components at higher or lower temperatures than the room. This ensures the functionality of the part in a wide range of temperature.

Package automated inspection

Automated interconnection mechanical inspection verifies the integrity of the piece, ensuring that it meets customer specifications.

Artificial weathering test

All electronic components are experiencing failures during their lives. Thus, once they have survived for some time, the chances of recurrence are low. Submit components to conditions of extreme temperature and aging can accelerate the onset of their manufacturing defects and ensure proper system operation.

Application engineering

The engineering department offers complete solutions for electrical tests from design to production.

  • Participation in the application design
  • Planning of the testing strategy including several design for test techniques
  • Selection of test equipment and test card design
  • Redaction of the test program, including the conversion of test vectors
  • Prototypes characterization
  • Optimization and production

Test program development

Our experienced technical staff provides a full range of services, including test program development. We understand the different applications and testing requirements, including digitals applications, mixed-signal, high speed, RF, and emerging technologies like 2.5 / 3D and SiPh.

From the test specifications, the test engineer will develop a test sequence to optimize the product quality, performance and cost.

Manufacturing solutions

Mass production is a critical step in the product’s life cycle. Throughout the development of the test solution, the engineering team considers the automated solution that will be used in mass production and set up all the tools necessary for this transition. Here is our expertise in manufacturing solutions:

  • Fully automated solutions
  • Multi-site programming
  • Lot management logistics
  • Returns and Maverick lots management
  • Capacity management
  • Test equipment management
  • Static analysis
  • Mathematical modeling
  • Data Mining
  • Expert systems
  • Customer returns management
  • Test programs updates
  • Testing time reduction during product’s life

Others

  • Migration of test program on different testers
  • Test vectors conversion
  • Burnin (products aging)
  • Application’s specific solution (on board test fixturing)
  • System level Test

Artificial weathering test

Functionality tests

Electrical verification
Electrical verification

Package automated inspection

Carrier inspection (topside)
Ball scanner

Electrical characterization

Short and Bias electrical test (module & card)
Manual characterization station
Signal Analyzer
High performance serial Bert
Mixed signal oscilloscope
RF analog signal generator
Samplig oscilloscope
Electrical characterization
Resitivity measures (2pts & 4pts)
Impedance measures

Handler

Test handler Tri-Temp.
Test handler Tri-Temp.

Lab opto

General Lab
High performance serial Bert
Lightwave multi channel system
Lightwave component analyzer
Photonic subassembly characterization tool
DCA-X Oscilloscope
General Lab

Thermal and mechanical characterization

Data acquisition rack
Pressure mapping and force measurement
Low force testing
Infrared camera
Flatness-surface shape measurement

SEARCH

Search for equipment by keyword
Category